Page 1 of 1
Multicam in a vertical timeline cuts off when reframing
Posted:
Fri Aug 25, 2023 2:54 pm
by dave4443
Why would this happen?
Is there a way to stop it from happening, I can't see any way that this behaviour is helpful lol
Re: Multicam in a vertical timeline cuts off when reframing
Posted:
Sat Aug 26, 2023 10:42 am
by dave4443
Anyone know a way around this except exporting the whole timeline and resizing it that way?
Re: Multicam in a vertical timeline cuts off when reframing
Posted:
Sat Aug 26, 2023 11:06 am
by panos_mts
Try the following steps:
1. Create a new timeline and uncheck the "Use Project Settings" checkbox.
2. In the format tab set the resolution the same as the source clips.
3. Go to the output tab, uncheck the "Use Timeline Settings for Output Scaling" and set the output resolution to a vertical resolution.
Re: Multicam in a vertical timeline cuts off when reframing
Posted:
Wed Sep 06, 2023 3:21 pm
by dave4443
panos_mts wrote:Try the following steps:
1. Create a new timeline and uncheck the "Use Project Settings" checkbox.
2. In the format tab set the resolution the same as the source clips.
3. Go to the output tab, uncheck the "Use Timeline Settings for Output Scaling" and set the output resolution to a vertical resolution.
Thanks for the suggestion! Sadly no it didn't work, it just cuts it off at the top and bottom this way
Re: Multicam in a vertical timeline cuts off when reframing
Posted:
Tue Mar 26, 2024 11:32 pm
by MichaelRM
Any progress on this? Hard to believe this could still be a problem but I am experiencing the edges cut off when reframing.
Re: Multicam in a vertical timeline cuts off when reframing
Posted:
Wed Apr 10, 2024 5:04 pm
by zycjam876
Would you believe that its still a problem in April 2024
Re: Multicam in a vertical timeline cuts off when reframing
Posted:
Fri Apr 19, 2024 3:10 am
by abaggett05
I'm having the same issue!!